BCR2000 like a Novation Launch key/control/pad

4 posts / 0 new
Last post
mfp
mfp's picture
BCR2000 like a Novation Launch key/control/pad

I would like to use BCR2000 with new iOS applications from Ampify music: Groovebox, launchpad and Blocs Wave. The applications mentioned above only work with controllers from Novation. I tried to assign CC commands to knobs identically as it is in Novation, but it turned out that the application so far does not refresh CC messages but receives notes but somehow they recognize these devices and work with them in feedback.

mfp
mfp's picture

Novation controlers works with InControl mode.
Do you have an idea how to adapt the InControl mode to BCR2000?

Royce
Royce's picture

Hi

InControl is a Midi driver that works, usually, as a HUI interface.

The BCs also have a Midi driver and the BCF can be started in HUI Mode
You could try to program the BCR to emulate HUI mode.

If you have access to a Novation controller, I would install the MidiYoke driver (if you don't already have it)
and then load up MidiOx.
In MidiOx...
Connect the InControl Midi In driver to MidiYoke1
Connect the InControl Midi Out driver to MidiYoke2
In your application where you would normally select the...
InControl Midi In driver select MidiYoke1 instead.
InControl Midi Out driver select MidiYoke2 instead.

I don't think Novation would use sysex, but you should enable sysex through in MidiOx (little SYX button
in the lower toolbar. You need deselect and re-select it when you change your routing in MidiOx

Now you should be able to see what the Novation Midi messages are.

All the best
Royce

mfp
mfp's picture

Thanks for the hint. As I will be able to access LaunchKey, I will try it.